Datalogic DM3610 - Modify Settings | Tach;Trigger;Transmit

DC3000 USER INTERFACE
69
4
4.7 MODIFY SETTINGS | TACH/TRIGGER/TRANSMIT
Use Tach/Trigger/Transmit to set up the tachometer source and trigger source. A range of
settings are definable based on use of hardware or software sources.
To set up tachometer and trigger sources:
1. In the tree menu under Modify Settings, navigate to Tach/Trigger/Transmit. The
Tach/Trigger/Transmit window opens.
NOTE: The information entered here supersedes the data
entered in the Tach/Trigger/Transmit page of the DM3610
User Interface for each individual dimensioner.
WARNING: Individual DM3610 dimensioners must be set to
Continuous Trigger in the DM3610 User Interface (Modify
Settings | Tach/Trigger/Transmit)
2. Enter the appropriate information in the form as described below.