ELECTRICAL INSTALLATION
3 ELECTRICAL INSTALLATION
WARNING: Electrical Installation must be performed by a Qualified
Service Technicians Only! A trained technician must perform any
procedures involving potential exposure to high voltage electricity. Do not
attempt to perform any electrical installation procedures unless you are a
trained technician.
IMPORTANT: This equipment contains electronics that may be affected
by electrostatic discharge (ESD). To prevent personal injury or damage to
the unit, please follow the safety precautions and warnings found in the
Introduction to this manual. Failure to follow these precautions may void
your warranty.
3.1 PREPARING FOR ELECTRICAL INSTALLATION
Before mounting any components, please do the following:
Read all instructions before beginning your installation.
Observe all electrical safety requirements discussed in the Introduction to this
manual.
Define and confirm the accuracy of your application’s requirements.
Review all installation-specific drawings.
Review and plan the power requirements for your application.
Review and plan the communications requirements for your application.
IMPORTANT: The content of this manual may be superseded by any
customer-specific documentation provided by Datalogic. Before proceeding
with any installation procedures, be sure to review ALL documentation,
especially content that contains details specific to your installation.
To Next Page
Loading...