ELECTRICAL INSTALLATION
3.14 SERIAL COMMUNICATION WIRING THROUGH DC3000
DIMENSIONING CONTROLLER
The dimensioning system provides serial RS-232/422 communications to other devices
through the DC3000 Dimensioning Controller.
There is one D-sub 9-pin connector on the front and one on the back panel that provide serial
communication.
COM1 (Serial port 1) on the rear panel supports RS-232 or RS-422 mode by BIOS selection.
The COM1 default setting is RS-232; if you want to use RS-422/485, make the change in
BIOS setup.
Figure 45: DC3000 Dimensioning Controller COM1 on rear panel
COM 3 (Serial Port #2) is available on the front panel and is RS-232 only.
Figure 46: DC3000 Dimensioning Controller COM3 on front panel
To Next Page
Loading...