2. Enter the appropriate information in the form as described below.
Select inch or mm from the drop-down list. Once the window is
updated, the dimensions displayed on this window will be
displayed in the unit type selected.
NOTE: Changing the units on this window
will not affect other windows in this user
interface. To change the measurement
units globally for the interface, see Modify
Settings | Configuration.
Select Longest Side, Direction of Travel, or Descending
order from the drop-down list.
Longest Side: The system assigns the length as the
larger of the two parcel measurement axes that are
parallel to the surface of the conveyor. The height is the
measurement axis that is perpendicular to the conveyor
surface.
Direction of Travel: The "length" will always be defined
as that parallel with the package direction of travel on the
conveyor.
Descending Order: The "length" is the largest value,
then width, and the smallest value is height. This
definition results in the same L, W, H assignment of the
measurements regardless of the parcel’s orientation
when measured.
To Next Page
Loading...