dbx DriveRack 480 - Page 53

®
Detailed Parameters
Section 4
DriveRack
™
41
DriveRack™ User Manual
Selects the desired Lowpass crossover frequency.
Highpass 2 - 20Hz to 20kHz
Selects the desired Highpass crossover frequency.
Low Slope 2 - 6-24dB/Octave
Sets the Lowpass slope of the crossover filter.
High Slope 2 - 6-24dB/Octave
Sets the Highpass slope of the crossover filter.
4.5.3 2-BAND CROSSOVERS - 1X2, 2X3,
2X4, 3X4, 3X6,
4X8
(N/A 442)
Low Fc - 20Hz to 20kHz
Selects the desired Lowpass crossover frequency.
Center Fc - 20Hz to 20kHz
Adjusts the Low Fc and High Fc together.
High Fc - 20Hz to 20kHz
Selects the desired Highpass crossover frequency.
Type - Butterworth (BW), Bessel and Linkwitz-Riley(L-R)
Selects the desired crossover filter type.
Low Slope - 6-24dB/Octave (BW, Bessel) 12-48dB/Octave (L-R)
Sets the Lowpass slope of the crossover filter.
High Slope - 6-24dB/Octave (BW, Bessel) 12-48dB/Octave (L-R)
Sets the Highpass slope of the crossover filter.
4.5.4 3-BAND CROSSOVERS - 1X3, 2X4W/SUB , 2X5, 2X6, 3X5,
3X8, 3X7W/SUB (N/A 442)
Low Fc 1 - 20Hz to 20kHz
Selects the desired Lowpass crossover frequency.
Center Fc 1 - 20Hz to 20kHz
Adjusts the Low Fc and High Fc together.
High Fc 1 - 20Hz to 20kHz
Selects the desired Highpass crossover frequency.
Type 1 - Butterworth (BW), Bessel and Linkwitz-Riley(L-R)
Selects the desired cross-over filter type.
Low Slope 1 - 6-24dB/Octave (BW, Bessel) 12-48dB/Octave (L-R)
Sets the Lowpass slope of the crossover filter.