70
SECTION 7
DriveRack
™
via the
480 R DriveRack™ The procedure for calling up and controlling slave units using the 480R
Remote Controller is quite simple.
•From Program mode, use the keypad on the front panel of the 480R to enter in the
unique device ID number of the unit that you wish to control, and then simply hit the
ENTER button as shown in the illustration below.
• Once the slave unit has been called up, the 480R will control all functionality of the
selected slave unit until a new unit has been selected.
7.3 Master/Slave Assignments cont’d
DriveRack™ User Manual
To Next Page
Loading...
