Chapter 4 Installation
PAGE 4-27
When the fastening judgment is NG (REJECT) (JDG: Judgment, OCR: Occurrence)
1 2 3 4 5 6 7 8 9 10 11 12 13 14
0 0 0 1 9 9 0 1 0 1
15 16 17 18 19 20 21 22 23 24 25 26 27 28
1 . 2 3 L 5 0 L
29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44
1 . 2 3 L 0 . 1 2 3
45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60
0 . 1 2 3 1 . 1 2 3 H X
61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76
1 0 . 0 2 . 0
77 78 79
CAUSE OF REJECT OCR
“X” (58H):This is set behind the data for
which the REJECT judgment was made first.
[PEAK TORQUE] JUDGMENT
"H"(48H): HIGH REJECT "L"(4CH): LOW REJECT
"A"(41H): ABNORMAL "S"(53H): STOP
"B"(42H): BYPASS “R”(52H): RESET
“D” (44H): START OFF (Off operation by lever performed during fastening)
The CAUSE OF REJECT OCR (OCR) is not set in the case of solitary
occurrence of "A," "B," "S," “R,” or “D.”
[FINAL TORQUE], [ANGLE], [RATE], [TIME] JUDGMENT
"H"(48H): HIGH REJECT "L"(4CH): LOW REJECT
TOTAL JUDGMENT
"X"(58H): Fastening
judgment REJECT
S0140185-H
To Next Page
Loading...