Chapter 6 Description of Operations
PAGE 6-8
6-4-2. Indications in the RUN Mode(Real time Mode)
In the real time mode, [Mon.] is indicated on the WORK Indication Part.
The value in the COUNT/D-No. indication part is incremented or decremented with the [▲] or [▼]
switch to change the indicated content.
Also, the value in the COUNT/D-No. indication part can be skipped by 5 at a time by
long-pressing the [▲] or [▼] switch.
“WORK” “COUNT/D-NO” “DATA”
Torque Value Indication
Torque Voltage Value Indication
Maximum Torque Value Indication
Used for in-house adjustment
Please refer to the “List of Contents Indicated in the Real Time Mode” regarding the respective data
contents indicated at the DATA indication part when “COUNT/D-No.” is changed.
・When the CAL switch or the RESET signal is input in the ”ON” state when any of
D-Nos. 3 ~ 7 is indicated, the torque will not be indicated at the upper stage of the
indicator (the check itself will be executed).
・When the CAL switch or the RESET signal is input in the ”ON” state in the real
time mode, “CAL” or “RES” will not be indicated in the D-No. indication part.
・"P - oFF" is displayed on the upper part of the display when the drive power supply
in the controller is not yet turned on.
[▲] switch or [▼] switch
(skipping by 5 at a time by
long-pressing)
S0140185-H
To Next Page
Loading...