DDK HFC3000II - 8-3. ID Data Input Setting

Chapter 8 Options
PAGE 8-10
8-3. ID Data Input Setting
As the selected data input interface, a fieldbus interface or the RS232C-2 interface can be
selected.
(Simultaneous input via fieldbus and the RS232C cannot be performed.)
When the ID data (equipment No.) is input before the fastening operation, the input data is added
to the fastening results, etc. and output from the HFC3000 User Console, the standard RS232C,
and the fieldbus.
[Notes on ID Data Input]
･Use ASCII of letter code data from "0x20" to "0x7E" except for the following.
"0x22", "0x27", "0x2A", "0x2F", "0x3A", "0x3C", "0x3E", "0x3F", "0x5C", "0x7C"
In the case of using other than above, There is a possibility that a display is garbled.
･The number of maximum memorizing: Up to 32 letters(32 Byte).
when a value beyond 32 letters is set, only the 32 bytes from the start are used.
･If the ID data is input continuously before the fastening operation,
the ID data is used all data that is input.
･Since acquiring the ID data to be used before the fastening operation,
Please complete the data transfer before the fastening operation.
･If the ID data is input during the fastening operation, will not be accepted.
･The data contents are held until the input of the next ID data.
･If the ID data is input after the fastening operation, the ID data is overwritten.
Caution
S0140185-H