Chapter 8 Options
PAGE 8-11
When the expansion RS232C is selected as the data input method and “Add STX/ETX” is set, the
ID data can be cleared when the STX signal is received via the RS232C-2 and data can be re-input
by finalizing the input data when the ETX signal is received. As the output ID data, the data excluding
the STX/ETX is stored.
● ID Data Output Timing ("A" in the figure requires an input time of 100 msec)
・Ex.1：the ID data is input continuously before the fastening operation
・Ex.2：the ID data is input during the fastening operation
・Ex.3：the ID data is not re-enter.
S0140185-H
To Next Page
Loading...