Chapter 6 Description of Operations
PAGE 6-25
Similar operations can be performed from “ErASE,” with “021” indicated in the D-No. indication part,
to erase all fastening result record stored in the Unit.
・ Be careful in executing erasing operation because data cannot be
recovered after the fastening result record is erased.
●Fastening Result Record Erasing Operation Procedure
1. When the Unit is in the PROGRAM mode, make “ErASE,” with “SYS” indicated in the WORK indication
part and “021” indicated in the COUNT/D-No. indication part, be indicated and then press “SET.”
2. Press the [▲] or [▼] switch to select “SinGLE” and then press “SET.”
3. After the indication at the DATA indication part changes to “ErASE YES,” press the [SET] switch within
2 seconds.
4. When the erasing of the fastening result record is started, “ErASE” in the DATA indication part flashes
for a few seconds and the flashing stops when the erasure is completed.
Erasure of
Fastening
Result Record
Canceled if not operated for 2 seconds.
S0140185-H
To Next Page
Loading...