104 omconfig system assetinfo: Editing Cost of Ownership Values
Adding Extended Warranty Information
Use the omconfig system extwarranty command to assign values for extended warranty information.
A warranty is a contract between the manufacturer or dealer and the purchaser of a system. The warranty
identifies the components that are covered for repair or replacement for a specified length of time or
usage. The extended warranty comes into force after the original warranty expires. For details on how to
edit warranty values, see "Adding Warranty Information."
Table 5-3 shows the valid parameters for the command.
Example Command for Adding Extended Warranty Information
To provide a value for an extended warranty parameter, type a command of the form: omconfig system
assetinfo info=extwarranty <name=value pair 2>. For example, type:
omconfig system assetinfo info=extwarranty enddate=012503
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-3. omconfig system assetinfo info=extwarranty
Command
level 1
Command
level 2
Command
level 3
name=value pair 1 name=value pair 2 Use
omconfig
system
assetinfo
info=extwarranty
cost=<cost> Cost of the extended
warranty service.
enddate=<enddate> Date the extended warranty
agreement ends.
provider=<provider> Business entity that provides the
extended warranty service.
startdate=<startdate> Date the extended warranty
service begins.
To Next Page
Loading...