omreport: Viewing System Status Using the Instrumentation Service 29
omreport chassis bmc
NOTE: This command will be phased-out in future releases. It will be replaced by the command omreport chassis
remoteaccess.
Use the omreport chassis bmc command to view baseboard management controller (BMC)
general information.
Ty p e :
omreport chassis bmc
The output from the omreport chassis bmc command lists each of the valid parameters. Table 3-3 shows
the available settings.
RAID Channel A Displays whether RAID-on-motherboard Channel A is detected as a
RAID device or a SCSI device.
RAID Channel B Displays whether RAID-on-motherboard Channel B is detected as a
RAID device or a SCSI device.
SATA Displays whether the onboard SATA controller is set to ATA mode,
RAID mode, or is disabled.
SATA port Displays if the SATA port is enabled or disabled.
Secondary SCSI Displays whether the device is enabled or disabled.
Serial Communications Displays whether COM port 1 and COM port 2 are enabled or
disabled with or without console redirection.
Serial Port 1 Displays whether serial port 1 is mapped to a COM port, a
COM port 1, a COM port 3, a COM1 BMC, a BMC Serial, a BMC
NIC, a BMC RAC, or is disabled.
Serial Port 2 Displays whether serial port 2 is mapped to a COM port, a
COM port 2, a COM port 4, or is disabled.
Speaker Displays whether the speaker is on or off.
USB or USBB Displays whether the USB port is enabled or disabled.
User accessible USB Displays whether the user-accessible USB port is enabled or disabled.
Table 3-2. BIOS Setup Parameters (continued)
Parameters Description
To Next Page
Loading...
Need help?
General
