Dell Command Line Interface - Adding System Information

omconfig system assetinfo: Editing Cost of Ownership Values 111
Adding System Information
System information includes the primary user of the system, the phone number for the primary user, and
the system location. Table 5-10 shows the valid parameters for adding system information.
Example Command for Adding System Information
To provide a value for a system parameter, type a command of the form: omconfig system assetinfo
info=system <name=value pair 2>. For example, type:
omconfig system assetinfo info=system location=firstfloor
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-10. omconfig system assetinfo info=system
Command
level 1
Command
level 2
Command
level 3
name=value
pair 1
name=value pair 2 Use
omconfig
system
assetinfo
info=system
location=<text> Location of the system.
primaryphone=<n> Phone number of the system's
primary user.
primaryuser=<user> Primary user of the system.