Dell Command Line Interface - Omreport Fan Status

Using the Storage Management Service 141
omreport Fan Status
controller=id enclosure=
<ENCLOSUREID>
info=temps index=n
where id is the controller number
and the enclosure number and “n” is
the number of a temperature probe.
For example: controller=0
enclosure=2 info=temps index=1
Displays the specified
temperature probe.
Table 8-10. omreport Fan Status
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information for
all enclosures attached to the system.
controller=id enclosure=
<ENCLOSUREID> info=fans
where id is the controller number
and the enclosure number.
For example: controller=0
enclosure=2
NOTE: For SCSI controllers, the ID
specified in enclosure=
<ENCLOSUREID> is the connector
number and for Serial Attached
SCSI (SAS) controllers, ID is the
connectorNumber:EnclosureIndex.
Displays the fans for the specified
enclosure.
controller=id enclosure=
<ENCLOSUREID>
info=fans index=n
where id is the controller number
and the enclosure number and “n”
is the number of a fan.
For example: controller=0
enclosure=2 info=fans index=1
Displays the specified fan.
Table 8-9. omreport Temperature Probe Commands
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use