130 omconfig rac: Managing the Remote Access Controller
Example Command
The following example sets one name=value pair.
Ty p e :
omconfig rac rmdialinuser username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
omconfig rac rmdialoutuser
Use the omconfig rac rmdialoutuser command to remove a dial-out user. Table 7-11 shows the valid
parameters for the command.
Example Command
The following example sets one name=value pair.
Ty p e :
omconfig rac rmdialoutuser username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
Table 7-11. omconfig rac rmdialoutuser
name=value pair Description
username=<text> Specifies the user name of entry which is to be deleted. If no
user name is specified, an index must be specified.
index=<n> Specifies the index of the entry which is to be deleted. If no
index is specified, a user name must be specified.
To Next Page
Loading...