Dell Command Line Interface User Manual

Using the Storage Management Service 173
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to assign physical disk 3 on connector 0 of controller 1 as a global hot spare.
On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers:
To assign the physical disk described in this example as a global hot spare, enter:
omconfig storage pdisk action=assignglobalhotspare controller=1
pdisk=0:3 assign=yes
Example for SAS Controllers:
To assign the physical disk described in this example as a global hot spare, enter:
omconfig storage pdisk action=assignglobalhotspare controller=1
pdisk=0:2:3 assign=yes
omconfig Unassign Global Hot Spare
Use the following omconfig command syntax to unassign a physical disk as a global hot spare.
Complete Syntax
omconfig storage pdisk action=assignglobalhotspare controller=id
pdisk=<PDISKID> assign=no
where id is the controller ID. The <PDISK> variable specifies the physical disk.
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to unassign physical disk 3 on connector 0 of controller 1 as a global hot spare.
On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers:
To unassign the physical disk described in this example as a global hot spare, enter:
omconfig storage pdisk action=assignglobalhotspare controller=1
pdisk=0:3 assign=no

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English