omreport: Viewing System Status Using the Instrumentation Service 41
• power supply warning
• power supply failure
• degraded redundancy
• lost redundancy
• temperature warning
• temperature failure
• voltage warning
• voltage failure
• processor warning
• processor failure
• hardware log warning
• hardware log full
• watchdog ASR
omreport system assetinfo
Use the omreport system assetinfo command to see cost of ownership data for the system, such as
acquisition, depreciation, and warranty information. To set any of these fields, you must use the
omconfig system assetinfo command. See "omconfig: Managing Components Using the
Instrumentation Service."
omreport system events
Use the omreport system events command to view the current enabled or disabled SNMP traps.
This command displays a summary of each component in your system for which events can be
generated. For each component, the report shows which severities are set to be reported and which
severities are set not to be reported. The following is an example output for a few components:
omreport system events
Current SNMP Trap Configuration
-----------
System
-----------
Settings
Enable: Informational, Warning and Critical
Disable: None
To Next Page
Loading...
Need help?
General
