omconfig system assetinfo: Editing Cost of Ownership Values 109
Adding Service Contract Information
A service contract is an agreement that specifies fees for preventive maintenance and repair of the
system. Table 5-8 shows the valid parameters for adding contract information.
Example Command for Adding Service Information
To provide a value for a service parameter, type a command of the form: omconfig system assetinfo
info=service <name=value pair 2>. For example, type:
omconfig system assetinfo info=service vendor=fixsystemco
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-8. omconfig system assetinfo info=service
Command
level 1
Command
level 2
Command
level 3
name=value pair 1 name=value pair 2 Use
omconfig
system
assetinfo
info=service
renewed=true | false Whether the service agreement
has been renewed.
type=<string> Type of service covered by
the contract.
vendor=<business> Business entity that offers service
on the system.
To Next Page
Loading...