Using the Storage Management Service 165
omconfig Cancel Check Consistency
Use the following omconfig command syntax to cancel a check consistency while it is in progress.
Complete Syntax
omconfig storage vdisk action=cancelcheckconsistency controller=id
vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to cancel a check consistency on virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=cancelcheckconsistency controller=1
vdisk=4
omconfig Pause Check Consistency
Use the following omconfig command syntax to pause a check consistency while it is in progress. See the
online help for more information.
Complete Syntax
omconfig storage vdisk action=pausecheckconsistency controller=id
vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to pause a check consistency on virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=pausecheckconsistency controller=1 vdisk=4
omconfig Resume Check Consistency
Use the following omconfig command syntax to resume a check consistency after it has been paused.
Complete Syntax
omconfig storage vdisk action=resumecheckconsistency controller=id
vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
To Next Page
Loading...
Need help?
General
