Dell Command Line Interface - Omconfig Enclosure Commands

Using the Storage Management Service 179
Example Syntax
For example, to rescan connector 2 on controller 1, enter:
omconfig storage connector action=rescan controller=1 connector=2
omconfig Enclosure Commands
The following sections provide the omconfig command syntax required to execute enclosure tasks.
Table 8-26. omconfig Enclosure Commands
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage enclosure
action=enablealarm controller=id enclosure=<ENCLOSUREID>
action=disablealarm controller=id enclosure=<ENCLOSUREID>
action=enablests
action=disablests
action=setassettag controller=id enclosure=<ENCLOSUREID>
assettag=<string>
action=setassetname controller=id enclosure=<ENCLOSUREID>
assetname=<string>
action=settempprobes controller=id enclosure=<ENCLOSUREID>
index=id minwarn=n maxwarn=n
action=resettempprobes controller=id enclosure=
<ENCLOSUREID> index=id
action=setalltempprobes controller=id
enclosure=<ENCLOSUREID> minwarn=n
maxwarn=n
action=resetalltempprobes controller=id
enclosure=<ENCLOSUREID>
action=blink controller=id
enclosure=<ENCLOSUREID>