Dell Command Line Interface User Manual

Using the Storage Management Service 143
omreport Physical Disk Status
controller=id enclosure=
<ENCLOSUREID>
info=emms index=n
where id is the controller number
and the enclosure number and “n”
is the number of an EMM.
For example: controller=0
enclosure=2
info=emms index=1
Displays the specified EMMs.
Table 8-13. omreport Physical Disk Commands
Required Command Levels (1, 2, 3) and
name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id
where id is the controller number. For
example: controller=0
Displays all physical disks
attached to the specified
controller.
connector=id
where id is the connector
number. For example:
connector=1
Displays all physical disks
attached to the specified
connector on the controller.
vdisk=id
where id is the virtual disk
number. For example: vdisk=1
Displays all physical disks
included in the specified virtual
disk on the controller.
pdisk=connectorID : targetID
| connectorID : enclosureID :
slotID
where connectorID:targetID is
the connector number and the
physical disk number and
connectorID:enclosureID:slotID
is the connector number,
enclosure number, and slot
number.
For example: pdisk=0:2 or
pdisk=0:1:2
Displays the specified physical
disk on the specified connector
on the controller.
Table 8-12. omreport EMM Commands (continued)
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English