106 omconfig system assetinfo: Editing Cost of Ownership Values
Adding Maintenance Information
Maintenance refers to activities required to keep the system in good working order. Table 5-5 shows the
valid parameters for adding maintenance information.
Example Command for Adding Maintenance Information
To provide a value for a maintenance parameter, type a command of the form: omconfig system
assetinfo info=maintenance <name=value pair 2>. For example, type:
omconfig system assetinfo info=maintenance startdate=012504
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-5. omconfig system assetinfo info=maintenance
Command
level 1
Command
level 2
Command
level 3
name=value pair 1 name=value pair 2 Use
omconfig
system
assetinfo
info=maintenance
enddate=<enddate> Date the extended warranty
agreement ends.
provider=<provider> Business entity providing the
maintenance service.
startdate=<startdate> Date the maintenance begins.
restrictions=<string> Activities not covered by the
maintenance contract.
To Next Page
Loading...