Dell Command Line Interface User Manual

112 omconfig system assetinfo: Editing Cost of Ownership Values
Adding Warranty Information
Use the omconfig system warranty command to assign values for warranty information. A warranty is a
contract between the manufacturer or dealer and the purchaser of a system. The warranty identifies the
components that are covered for repair or replacement for a specified length of time or usage. For details
on how to edit extended warranty values, see "Adding Extended Warranty Information." Table 5-11
shows the valid parameters for adding warranty information.
Example Command for Adding Warranty Information
To provide a value for a warranty parameter, type a command of the form: omconfig system assetinfo
info=warranty <name=value pair 2>. For example, type:
omconfig system assetinfo info=warranty unit=days
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-11. omconfig system assetinfo info=warranty
Command
level 1
Command
level 2
Command
level 3
name=value pair 1 name=value
pair 2
Use
omconfig
system
assetinfo
info=warranty
cost=<cost> Cost of the warranty service.
duration=
<duration>
Number of days or months that the
warranty is in force.
enddate=
<enddate>
Date the warranty agreement ends.
unit=days |
months
Whether the number for duration refers to
days or months.

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English