Using the Storage Management Service 161
Complete Syntax
omconfig storage vdisk action=fastinit controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, you would enter omreport storage controller to display the controller IDs and then enter
omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to fast initialize virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=fastinit controller=1 vdisk=4
omconfig Slow Initialize Virtualize Disk
Use the following omconfig command syntax to slow initialize a virtual disk.
Complete Syntax
omconfig storage vdisk action=slowinit controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, you would enter omreport storage controller to display the controller IDs and then enter
omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to slow initialize virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=slowinit controller=1 vdisk=4
omconfig Cancel Background Initialize
Use the following omconfig command syntax to cancel the background initialization process on a
virtual disk.
Complete Syntax
omconfig storage vdisk action=cancelbginitialize controller=id
vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these
values, enter omreport storage controller to display the controller IDs and then enter omreport storage
vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to cancel background initialization on virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=cancelbginitialize controller=1 vdisk=4
To Next Page
Need help?
General
