Using the Storage Management Service 175
Example Syntax
In this example, you want to cancel the rebuild or physical disk 3 on connector 0 of controller 1. On a
SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers:
To cancel the rebuild of the physical disk described in this example, enter:
omconfig storage pdisk action=cancelrebuild controller=1 pdisk=0:3
Example for SAS Controllers:
To cancel the rebuild of the physical disk described in this example, enter:
omconfig storage pdisk action=cancelrebuild controller=1 pdisk=0:2:3
omconfig Remove Dead Segments
Use the following omconfig command syntax to recover unusable disk space. See the online help for
more information.
Complete Syntax
omconfig storage pdisk action=removedeadsegments controller=id
pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical disk.
To obtain these values, enter omreport storage controller to display the controller IDs and then enter
omreport storage pdisk controller=ID to display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to remove dead disk segments on physical disk 3 on connector 0 of controller 1.
On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers:
To remove dead segments on the physical disk described in this example, enter:
omconfig storage pdisk action=removedeadsegments controller=1 pdisk=0:3
Example for SAS Controllers:
To remove dead segments on the physical disk described in this example, enter:
omconfig storage pdisk action=removedeadsegments controller=1 pdisk=
0:2:3
omconfig Clear Physical Disk
Use the following omconfig command to clear data or a configuration from a physical disk.
To Next Page
Loading...
Need help?
General
