Dell Command Line Interface User Manual

omreport: Viewing System Status Using the Instrumentation Service 43
Example Command for Event Type
When you type:
omreport system events type=fans
The following is an example output:
-----------
Fans
-----------
Settings
Enable: Critical
Disable: Informational and Warning
omreport system operatingsystem
Use the omreport system operatingsystem command to display operating system information.
omreport system pedestinations
Use the omreport system pedestinations command to view destinations where alerts for platform events
are configured to be sent. Depending on the number of destinations displayed, you can configure a
separate IP address for each destination address.
Ty p e :
omreport system pedestinations
The output from the omreport system pedestinations command lists each of the valid parameters.
NOTE: The actual number of destinations that can be configured on your system may differ.
Table 3-7 shows the available settings.
Table 3-7. omreport system pedestinations
Output Attributes Description
Destination List
Destination Number: Destination1
Destination IP Address: 101.102.103.104
destination 1: Displays the first
destination.
101.102.103.104: IP address of the first
destination.
Destination Number: Destination 2
Destination IP Address: 110.120.130.140
destination 2: Displays the second
destination.
110.120.130.140: IP address of the
second destination.

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English