omconfig system assetinfo: Editing Cost of Ownership Values 107
Adding Outsource Information
Outsourcing is the practice of contracting with another business to maintain the system in good working
order. Table 5-6 shows the valid parameters for adding outsource information.
Example Command for Adding Outsource Information
To provide a value for an outsource parameter, type a command of the form: omconfig system assetinfo
info=outsource <name=value pair 2>. For example, type:
omconfig system assetinfo info=outsource providerfee=75
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-6. omconfig system assetinfo info=outsource
Command
level 1
Command
level 2
Command
level 3
name=value pair 1 name=value pair 2 Use
omconfig
system
assetinfo
info=outsource
levels=<n> Levels of service offered by the
provider.
problemcomponent=
<component>
System component that
requires maintenance.
providerfee=<providerfee> Amount of money charged for
maintenance.
servicefee=<servicefee> Amount of money charged for
service.
signauth=<name> Person who signed or
authorized the service.
To Next Page
Loading...