148 Using the Storage Management Service
omconfig Enable Controller Alarm
Use the following omconfig command syntax to enable the controller alarm. See the online help for
more information about using this command.
Complete Syntax
omconfig storage controller action=enablealarm controller=id
where id is the controller ID as reported by the omreport storage controller command.
Example Syntax
For example, to enable the alarm on controller 1, enter:
omconfig storage controller action=enablealarm controller=1
omconfig Disable Controller Alarm
Use the following omconfig command syntax to disable the controller alarm. See the online help for
more information about using this command.
Complete Syntax
omconfig storage controller action=disablealarm controller=id
where id is the controller ID as reported by the omreport storage controller command.
Example Syntax
For example, to disable the alarm on controller 1, enter:
omconfig storage controller action=disablealarm controller=1
omconfig Quiet Controller Alarm
Use the following omconfig command syntax to silence an activated controller alarm. See the online
help for more information about using this command.
Complete Syntax
omconfig storage controller action=quietalarm controller=id
where id is the controller ID as reported by the omreport storage controller command.
Example Syntax
For example, to quiet the alarm on controller 1, enter:
omconfig storage controller action=quietalarm controller=1
To Next Page
Loading...