Dell Command Line Interface - Omreport Enclosure Status; Omreport Temperature Probe Status

140 Using the Storage Management Service
omreport Enclosure Status
omreport Temperature Probe Status
controller=id
where id is the controller
number. For example:
controller=0
connector=id
where id is the connector
number. For example:
connector=0
Displays information for the specified
connector on the controller.
Table 8-8. omreport Enclosure Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage enclosure Displays property information for
all enclosures attached to the
system.
controller=id enclosure=
<ENCLOSUREID>
where id is the controller number
and the enclosure number. For
example: controller=0
enclosure=2
Displays the specified enclosure
and its components.
Table 8-9. omreport Temperature Probe Commands
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
omreport storage enclosure Displays property information
for all enclosures attached to
the system.
controller=id enclosure=
<ENCLOSUREID>
info=temps
where id is the controller number
and the enclosure number. For
example: controller=0 enclosure=2
Displays the temperature probes
for the specified enclosure.
Table 8-7. omreport Connector Commands (continued)
Required Command Levels (1, 2, 3) Optional name=value pairs Use