138 Using the Storage Management Service
omreport Storage Help
The following table provides the omreport storage command syntax.
omreport Controller Status
Table 8-3. omreport storage help
Command Level 1 Command Level 2 Command Level 3 Use
omreport
storage Displays a list of storage components for which omreport
commands are available.
pdisk Displays a list of the omreport storage pdisk parameters for
displaying physical disk information.
vdisk Displays a list of omreport storage vdisk parameters for
displaying virtual disk information.
controller Displays a list of the omreport storage controller
parameters for displaying controller information.
enclosure Displays a list of the omreport storage enclosure
parameters for displaying enclosure information.
connector Displays a list of the omreport storage connector
parameters for displaying connector information.
battery Displays a list of the omreport storage battery parameters
for displaying battery information.
globalinfo Displays a list of the omreport storage globalinfo
parameters for displaying global storage property
information.
Table 8-4. omreport Controller Commands
Required Command Levels (1, 2, 3) Optional name=value pairs Use
omreport storage controller Displays property information for
all controllers attached to the
system.
controller=id
where id is the controller number.
For example: controller=0
Displays the specified controller
and all attached components such
as enclosures, virtual disks,
physical disks, and so on.
To Next Page
Loading...
Need help?
General
