Dell Command Line Interface User Manual

168 Using the Storage Management Service
Complete Syntax
action=rename controller=id vdisk=id name=<string>
where id is the controller ID and virtual disk ID as reported by the omreport command and <string> is the
new name for the virtual disk. To obtain the values for controller ID and virtual disk ID, enter omreport
storage controller to display the controller IDs and then enter omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to rename virtual disk 4 on controller 1 to vd4, enter:
omconfig storage vdisk action=rename controller=1 vdisk=4 name=vd4
omconfig Physical Disk Commands
The following sections provide the omconfig command syntax required to execute physical disk tasks.
omconfig Blink Physical Disk
You can blink the light (light emitting diode or LED display) on one or more physical disks attached to a
controller. Use the following omconfig command syntax to blink one or more physical disks.
Table 8-23. omconfig Physical Disk Commands
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage pdisk
action=blink controller=id pdisk=<PDISKID>
action=unblink controller=id pdisk=<PDISKID>
action=remove controller=id pdisk=<PDISKID>
action=initialize controller=id pdisk=<PDISKID>
action=offline controller=id pdisk=<PDISKID>
action=online controller=id pdisk=<PDISKID>
action=assignglobalhotspare controller=id pdisk=<PDISKID>
assign=<yes|no>
action=rebuild controller=id pdisk=<PDISKID>
action=cancelrebuild controller=id pdisk=<PDISKID>
action=removedeadsegments controller=id pdisk=<PDISKID>

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English