Dell Command Line Interface User Manual

omconfig: Managing Components Using the Instrumentation Service 95
omconfig system events
Use the omconfig system events command to enable and disable SNMP traps for components on
your system.
NOTE: Not all event types may be present on your system.
There are four parameters in the name=value pair component of the omconfig system events command:
•source
•type
• severity
• index
Source
At present, source=snmptraps is a required name=value pair because SNMP is currently the only
supported source of event notification for your system’s components.
omconfig system events source=snmptraps
Type
The event type refers to the name of the component(s) involved in the event. Table 4-25 shows the valid
parameters for system event types.
Table 4-25. System Event Type Parameters
name=value pair Description
type=accords Configures events for AC power cords.
type=battery Configures events for battery.
type=all Configures events for all device types.
type=currents Configures events for amperage.
type=fanenclosures Configures events for fan enclosures.
type=fans Configures events for fans.
type=intrusion Configures events for chassis intrusion.
type=log Configures events for logs.
type=memory Configures events for memory.
type=powersupplies Configures events for power supplies.
type=redundancy Configures events for redundancy.
type=temps Configures events for temperatures.
type=volts Configures events for voltages.

Dell Command Line Interface Specifications

General

Brand	Dell
Model	Command Line Interface
Category	Network Card
Language	English