94 omconfig: Managing Components Using the Instrumentation Service
event=fanfail Sets action or enables/disables alert generation when a fan probe detects that the
fan is running too slow or not at all.
event=hardwarelogfail Enables/disables alert generation when a hardware log detects a failure value.
event=intrusion Sets action or enables/disables alert generation when a chassis has been opened.
event=powerwarn Sets action or enables/disables alert generation when a power device probe detects
that the power supply, voltage regulator module, or DC to DC converter is
pending a failure condition.
event=powerabsent Sets action or enables/disables alert generation when a processor probe detects
that the power supply is absent.
event=powerfail Sets action or enables/disables alert generation when a power device probe detects
that the power supply, voltage regulator module, or DC to DC converter has failed.
event=processorwarn Sets action or enables/disables alert generation when a processor probe detects
that the processor is running at less than peak performance or speed.
event=processorfail Sets action or enables/disables alert generation when a processor probe detects
that the processor has failed.
event=processorabsent Sets action or enables/disables alert generation when a processor probe detects
that the processor is absent.
event=redundegrad Sets action or enables/disables alert generation when the system’s fans and/or
power supplies become inoperative, resulting in less than full redundancy for that
component.
event=redunlost Sets action or enables/disables alert generation when the system’s fans and/or
power supplies become inoperative, resulting in a lost or a "no redundant
components working" condition for that component.
event=tempwarn Sets action or enables/disables alert generation when a temperature probe detects
that the temperature is approaching the maximum high or low limits.
event=tempfail Sets action or enables/disables alert generation when a temperature probe detects
that the temperature is either too high or low for proper operation.
event=voltfail Sets action or enables/disables alert generation when a voltage probe detects that
the voltage is too low for proper operation.
event=watchdogasr Enables or disables alert generation configured by the ASR when the system has
hung or is not responding.
Table 4-24. omconfig system platformevents (continued)
Event Name Description
To Next Page
Loading...
Need help?
General
