omconfig system assetinfo: Editing Cost of Ownership Values 105
Adding Lease Information
A lease is an agreement to pay for the use of a system for a specified period of time. The lessor retains
ownership of the system. Table 5-4 shows the valid parameters for the command.
Example Command for Adding Lease Information
To provide a value for a lease parameter, type a command of the form: omconfig system assetinfo info=
lease <name=value pair 2>. For example, type:
omconfig system assetinfo info=lease value=4500
The following message appears:
Asset information set successfully.
You can enter more than one omconfig system assetinfo command at the same time, as long as all of the
parameters for name=value pair 2 belong to the same name=value pair 1. For an example, see "Example
Commands for Adding Acquisition Information."
Table 5-4. omconfig system assetinfo info=lease
Command
level 1
Command
level 2
Command
level 3
name=value pair 1 name=value pair 2 Use
omconfig
system
assetinfo
info=lease
buyout=<amount> Amount of money paid to purchase
a system from a lessor.
lessor=<lessor> Business entity that is leasing the
system out.
multischedule=true |
false
Whether cost of leasing the system
is computed by more than one rate
schedule.
ratefactor=<factor> Factor used to calculate the lease
payment.
value=<residual> Fair market value of the system at
the end of the lease period.
To Next Page
Loading...
Need help?
General
