omconfig rac: Managing the Remote Access Controller 133
Example Command
The following example sets one name=value pair. Type:
omconfig rac users username=jdoe
The following message appears:
Command Successful. Please reset RAC card!
numericpagingenable=true | false true: Enables numeric paging.
false: Disables numeric paging.
numericpagernumber=<n> Sets the numeric pager number.
numericpagermsg=<text> Sets the numeric pager message.
emailpagingenable=true | false true: Enables e-mail paging.
false: Disables e-mail paging.
emailaddress=<text> Sets the e-mail address.
emailmsg=<text> Set the e-mail message.
alphapagingenable=true | false true: Enables the alpha paging.
false: Disables the alpha paging.
alphanumber=<n> Sets the alpha number.
alphaprotocol=8N1 | 7E0 Sets the alpha protocol.
alphabaudrate=<n> Sets the alpha baud rate.
alphapagerid=<n> Sets the alpha pager ID.
apphacustommsg=<text> Sets the alpha custom message.
alphapagerpassword=<text> Sets the alpha pager password.
Table 7-15. omconfig rac users (continued)
name=value pair Description
To Next Page
Loading...