Introduction and Preparation
Topics:
• Document purpose
•
DD9410 and DD9910 system features
• Locating the Express Service Code and Service Tag
• Required tools and supplies
• Safety considerations
• Working with a portable lift
Document purpose
This installation guide provides instructions for installing the hardware associated with PowerProtect systems. Systems are
shipped to the customer site either pre-installed in a rack (factory-racked) or as separate components to install in an existing
rack at the site (field-installed). This guide provides instructions for both types of installation.
This document is intended for customers or Dell Support personnel who are qualified to install PowerProtect systems.
Field-installed systems
To install PowerProtect systems in an existing rack at the customer site, follow all the instructions in this document to rack,
cable, and configure the system.
Factory-racked systems
Factory-racked systems are pre-installed in the rack with the cables already connected. Follow the instructions in Configure
System for Use to configure factory-racked systems.
The following documents, available from the Online Support website, provide additional information about factory-racked
systems:
● Dell 40U-P Cabinet Site Preparation Guide
● Dell 40U-P Cabinet Unpacking and Setup Guide
● Dell Titan S Site Preparation Guide
● Dell Titan S Unpacking and Setup Guide
● Dell Data Domain Rack Service Guide
DD9410 and DD9910 system features
Table 1.
DD9410 system features
Features Single Node HA
Processor 2 x Intel Xeon 5416S, 16C, 2.1/2.9GHz, 150W
Kernel 5.4
Memory Configurations Total 768 GB
DIMMs 12 x 64 GB
HDD Drive Size Active Tier storage 8 TB
1
10 Introduction and Preparation
To Next Page