ok, proceeding.
The system is going down for reboot.
9. After the system completes the reboot, login again as sysadmin using the serial number as a password. Press Ctrl-C to
get through the EULA, sysadmin password prompt, and config setup wizard.
10. Generate an autosupport sent to yourself to use as ACG input:
# autosupport send your.email@emc.com
OK: Message sent.
Using the system configuration wizard
The DD System Manager wizard guides you through a simplified configuration to get your system operating quickly. After you
complete the basic configuration with a wizard, you can use DD System Manager and the CLI to further configure your system.
Steps
1. Select Maintenance > System > Configure System.
2. Use the controls at the bottom of the Configuration Wizard dialog box to select which features to configure and to
advance through the wizard.
Basic Input/Output System (BIOS) page
Change the BIOS setup password.
Changing the BIOS setup password during DDOS configuration
Press Reboot to commit the new BIOS setup password.
NOTE: After the reboot is complete, the new password is required to make any changes in the BIS screen.
Changing the BIOS setup password after the DDOS configuration is complete
After the DDOS System Configuration Wizard is complete, the BIOS setup password may be changed again from the iDRAC GUI
or the BIOS screen:
● From the iDRAC GUI, select: Configuration > BIOS Settings > System Security > Setup Password
● From the BIOS screen (after pressing F2 during the boot process) to enter the BIOS, select: System Setup > System
BIOS > System Security > Setup Password
Troubleshooting BIOS setup password change failures
If the system returns an error when changing the BIOS setup password, complete the following steps:
1. Reboot iDRAC from the iDRAC GUI:Maintenancve > Reboot iDRAC
2. Reboot DDOS from the iDRAC GUI: Dashboard > Reset System (warm boot)
3. Try again to change the BIOS setup password.
62
Configure System for Use
To Next Page
Loading...
