Dell DD9410 - Page 89

NOTE: The customer must accept the EULA. A Dell representative should not accept this agreement. If a customer is
not present, press Ctrl-C to exit from the EULA acceptance screen and continue with the configuration. The customer
can run the system show eula command to display and accept the EULA at a later time.
8. Run the configuration wizard.
The CLI configuration wizard starts automatically the first time the system starts. The wizard prompts you through a series
of questions that provide just enough information for initial system configuration and basic network connectivity.
NOTE: You can begin the CLI configuration wizard manually by typing config setup.
9.
Enter yes to configure the system for network connectivity.
Network Configuration
Configure Network at this time (yes|no) [no]:
yes
10. Select whether or not to use DHCP.
The HA configuration will fail if one node is configured to use DHCP and the other node is configured to use static IP
addresses. Both nodes must use the same method to configure IP addresses.
Use DHCP
Use DHCP for hostname, domainname, default gateway
and DNS servers? (At least one interface needs to
be configured using DHCP) (yes|no|?)
11. Enter a fully qualified domain name (FQDN) for the host name; for example, str01.yourcompany.com. Or accept the
host name, if the system was able to discover it.
Enter the hostname for this system
(fully-qualified domain name)[]:
12. Enter the DNS (Domain Name System) domain name; for example, yourcompany.com. Or accept the domain name, if the
system was able to discover it.
Domainname
Enter your DNS domainname []:
13. Enable and configure the Ethernet management interface, ethMa. Accept or decline DHCP. If the port does not use DHCP to
discover network parameters automatically, enter the information manually.
NOTE: Do not configure any other interfaces at this time.
Ethernet port ethLa
Enable Ethernet port ethLa (yes|no|?) [yes]:
no
Ethernet port ethLb
Enable Ethernet port ethLb (yes|no|?) [no]:
no
Ethernet port ethMa
Enable Ethernet port ethMa (yes|no|?) [no]:
no
Use DHCP on Ethernet port ethMa (yes|no|?) [no]:
Enter the IP address for ethMa [192.168.10.185]:
Enter the netmask for ethMa [255.255.255.0]:
14. Enter the IP address of the default routing gateway. Or accept the default gateway, if the system was able to discover it.
Default Gateway
Enter the default gateway IP address:
192.168.10.1
15. Enter the IPv6 address of the default routing gateway. Or accept the IPv6 address of the default gateway, if the system was
able to discover it. If IPv6 is not in use, leave the field empty, and press Enter to continue.
IPV6 Default Gateway
Enter the ipv6 default gateway IP address:
Single Node to HA Upgrade
89