Dell E60S - Intrusion Switch; Removing the Intrusion Switch

Figure 25. Installing the air shroud
Next steps
1. Install the system cover.
2. Follow the procedure listed in Before working inside your system.
Intrusion switch
Removing the intrusion switch
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Keep the plastic scribe ready.
Steps
1. Disconnect the intrusion switch cable connector from the system board.
NOTE:
Observe the routing of the cable as you remove it from the system. Route the cable properly when you replace it
to prevent the cable from being pinched or crimped.
2. Using the plastic scribe, slide the intrusion switch out of the intrusion switch slot.
30
Installing and removing system components