Dell E60S - Removing a 3.5-Inch Drive Adapter from a 3.5-Inch Drive Carrier

Figure 35. Installing a 2.5-inch drive into the 3.5-inch drive adapter
Next steps
1. Replace a 3.5-inch adapter into the 3.5-inch drive carrier.
2. Follow the procedure listed in After working inside your system.
Removing a 3.5-inch drive adapter from a 3.5-inch drive carrier
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the 3.5-inch drive carrier from the system.
Steps
1. Remove the screws from the rails on the drive carrier.
NOTE: If the 3.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the drive from a 3.5-inch drive adapter.
2. Lift the 3.5 inch drive adapter out of the drive carrier.
Installing and removing system components
39