Dell E60S - Drives; Removing a Drive Blank; Installing a Drive Blank

Next steps
1. Install the air shroud.
2. Follow the procedure that is listed in After working inside your system.
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the front bezel.
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release tab, and slide the drive blank out.
Figure 28. Removing a drive blank
NOTE: The procedure to remove a 2.5-inch or a 3.5-inch drive blank is the same.
Next steps
1. Replace the drive or a drive blank.
Installing a drive blank
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedure in Before working inside your system.
3. Remove the front bezel.
CAUTION: To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION: Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Slide the drive blank into the drive slot until the release tab clicks into place.
32
Installing and removing system components