About this task
The following image indicates the location of the display cable and provides a visual representation of the installation procedure.
Steps
Adhere the adhesive tape to the eDP cable and to the display cover.
Next steps
1. Install the display hinges.
2. Install the camera.
3. Install the display bezel.
4. Install the display assembly.
5. Install the system board.
6. Install the rear I/O board.
7. Install the dock I/O board.
8. Install the WWAN card.
9. Install the WLAN card.
10. Install the Wi-Fi I/O board.
11. Install the heat-sink (UMA) or heat-sink (discrete).
12. Install the fan.
13. Install the base cover.
14. Install the keyboard.
15. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
16. Install the battery.
17. Follow the procedure in after working inside your computer.
102
Removing and installing components
To Next Page
Loading...
