Dell Latitude 5430 Rugged - Touchpad; Removing the Touchpad

Steps
After performing the succeeding steps, you are left with the display back cover.
Next steps
1. Install the display cable.
2. Install the display hinges.
3. Install the camera.
4. Install the display bezel.
5. Install the display assembly.
6. Install the system board.
7. Install the heat-sink (UMA) or heat-sink (discrete).
8. Install the fan.
9. Install the rear I/O board.
10. Install the dock I/O board.
11. Install the WWAN card.
12. Install the WLAN card.
13. Install the Wi-Fi I/O board.
14. Install the base cover.
15. Install the keyboard.
16. Install the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
17. Install the battery.
18. Follow the procedure in after working inside your computer.
Touchpad
Removing the touchpad
Prerequisites
● Follow the procedure in before working inside your computer.
● Remove the battery.
Removing and installing components
109