Steps
1. Slip the stylus through the hole to create a knot that holds the tether to the chassis.
2. Insert the stylus into the slot on the system.
NOTE: When not in use, avoid hanging the stylus that is detached from its groove.
Next steps
1. Follow the procedure in after working inside your computer.
Handle
Removing the handle
Prerequisites
NOTE: The handle screw is part of the handle assembly and cannot be ordered separately.
1. Follow the procedure in before working inside your computer.
About this task
The following images indicate the location of the handle and provide a visual representation of the removal procedure.
28
Removing and installing components
To Next Page
Loading...
