6. Follow the procedure in after working inside your computer.
LED board
Removing the LED board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
4. Remove the base cover.
About this task
The following images indicate the location of the LED board and provide a visual representation of the removal procedure.
Steps
1. Disconnect the LED cable from the connector on the system board.
2. Remove the two (M2x3.5) screws that secure the LED board to the system chassis.
3. Lift the LED board from the system chassis.
Installing the LED board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the LED board and provides a visual representation of the installation procedure.
Removing and installing components
53
To Next Page
Loading...
