Steps
1. Peel the adhesive tape and unroute the cables from the routing channels on the system chassis.
2. Disconnect the rear I/O flat printed cable and remove the two (M2.5x5) screws that secure the rear I/O board to the
system board.
NOTE: Disconnect the GPS cable and tilt the rear I/O board at an angle to remove it.
Installing the rear I/O board
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the rear I/O board and provides a visual representation of the installation
procedure.
Removing and installing components
65
To Next Page
Loading...
