Installing the right Type-C daughterboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the right Type-C daughterboard and provides a visual representation of the
installation procedure.
Steps
1. Place the right Type-C daughterboard on the system chassis.
2. Remove the four (M2x3.5) screws that secure the right Type-C daughterboard to the system chassis.
3. Connect the flat printed cable to its connector on the right Type-C daughterboard.
4. Connect the flat printed cable to its connector on the right Type-C daughterboard.
5. Replace the (M2x3.5) screw that secures the flat printed cable holder to the right Type-C daughterboard.
Next steps
1. Install the system board.
2. Install the rear I/O board.
3. Install the dock I/O board.
4. Install the WWAN card.
5. Install the WLAN card.
Removing and installing components
79
To Next Page
Loading...
