Steps
1. Place the keyboard on the system chassis.
2. Connect the keyboard and backlight flexible printed cables to the connectors on the system board.
Adhere the keyboard and backlight flexible printed cable with kapton tapes to the connectors.
3. Replace the four (M2x3.5) screws that secure the keyboard cover to the system chassis.
4. Flip the keyboard on the chassis and slide it towards the display to align with the screw holes.
5. Replace the six (M2.5x4) screws to secure the keyboard.
Next steps
1. Install the battery.
2. Follow the procedure in after working inside your computer.
Base cover
Removing the base cover
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the battery.
3. Remove the primary M.2 2280 solid state drive or primary M.2 2230 solid state drive.
About this task
The following images indicate the location of the base cover and provide a visual representation of the removal procedure.
36
Removing and installing components
To Next Page
Loading...
