5. Lift the secondary daughterboard from the system chassis.
Installing the secondary daughterboard
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the secondary daughterboard and provides a visual representation of the
installation procedure.
Steps
1. Align the screw holes and replace the two (M2x3.5) screws that secure the secondary daughterboard with system chassis.
2. Connect the contactless smartcard flat printed cable and fingerprint cable to the connector on the secondary
daughterboard.
Adhere the contactless smartcard flat printed cable and fingerprint cable with kapton tapes to the connector.
3. Connect the touchpad flat printed cable to the connector on the touchpad.
4. Connect the secondary daughterboard flat printed cable and smart card cable to the connector on the secondary
daughterboard.
Adhere the secondary daughterboard flat printed cable and smart card cable with kapton tapes to the connector.
60
Removing and installing components
To Next Page
Loading...
